A6 A5 Snap frames with table stands

To change the picture simply open the four sides of the frame and insert your paper or photo behind the supplied plastic cover sheet.

The support leg clips into place and can be located to suit either portrait of landscape display.  It can be folded away when not in use or for wall mounting.

The silver version has a grey back panel and support strut.
The black version has a black back panel and fold-out support strut.

Size Information for Opti snap frames

• The width of the surround is 1.4cm = 14mm
• Front to back depth of 14mm profile snap frame: 13.2mm
• A6 relates to the size of paper an A6 frame will fit.
• A narrow strip around the edge of your print is hidden when the frame is closed.
  Visible poster size: 10mm less than actual poster (i.e. 5mm all round your poster is hidden by the frame surround) 
• The overall size of the frame is larger than the paper inserted.
  Overall (external) frame sizes are shown in the table:

Table of Opti snap frame sizes - relates to 14mm wide profile frames

Opti frames are supplied fully assembled and individually boxed.

Hang Opti frames on a picture hook

• Smaller Opti snap frames up to and including A3 size can be hung on a single picture pin nailed into the wall.
• The back of the frame provides this facility whether the frame is to be mounted portrait or landscape 
• Hanging a snap frame on a picture hook, nail or tack only requires a hammer. 
• Picture hooksand tacks are not supplied. They are available from hardware stores.

Fix Opti frames using screws

• The usual way to permanently fix Opti frames is with screws.
• Screws and plastic wall plugs are included with every snap frame we supply
• The wall plugs are for use with masonry walls such as brick and most plastered walls 
• When screwing onto wood the plugs are not needed 
• A drill and screwdriver are required for screw fixing (and we recommend using a spirit level and tape measure to ensure the frames are properly aligned). If in doubt please consult a proficient DIY or trades person.

Fix Opti frames using adhesive tape

• Rolls of double-side adhesive tape are available as an accessory item.
• If double-side adhesive tape is used to fix frames (in place of the screws supplied) please check the smoothness and suitability of the wall.
• Tiles and similar surfaces may be suitable provided they are cleaned thoroughly before application.
• Tape fixing is not suitable for surfaces with a non-stick coating or porous/foamed surfaces. 
• We recommend that tape is used around the full perimeter of the frame.
• Larger frames are normally best screwed. A residue of foam tape will be left on the wall or door after removal of the frame and the frame will usually be hard to get off.