A4 Counter top Snap Frame Sign holders

If you want A4 Opti Frames without support legs click on A4 Snap Frames 

The Opti frame with support stand is the ideal A4 snap frame when you're not sure how the frame will be used - e.g. for sending out approved dealer certificates, which could be wall-hung or stood on the sales counter.

• The above image shows how the folding support strut is slotted into grooves provided in the back panel and engaged to lock into place.
• When not required it folds away neatly into the recessed back of the frame.
• Repositioning the leg to change orientation of the frame from landscape to portrait (and vice versa) is accomplished with ease in a few seconds.

Size Information for Opti snap frames

• The width of the surround is 2.5cm = 25mm or 1 inch
• Front to back depth of 25mm profile snap frame: 17.4mm
• A4 relates to the size of paper an A4 frame will fit.
• A narrow strip around the edge of your print is hidden when the frame is closed.
  Visible poster size: 19mm less than actual poster (i.e. 9.5mm all round your poster is hidden by the frame surround) 
• The overall size of the frame is larger than the paper inserted.
  Overall (external) frame sizes are shown in the table:

Opti frame sizes

Opti frames are supplied fully assembled and individually boxed.

Hang Opti frames on a picture hook

• Smaller Opti snap frames up to and including A3 size can be hung on a single picture pin nailed into the wall.
• The back of the frame provides this facility whether the frame is to be mounted portrait or landscape 
• Hanging a snap frame on a picture hook, nail or tack only requires a hammer. 
• Picture hooksand tacks are not supplied. They are available from hardware stores.

Fix Opti frames using screws

• The usual way to permanently fix Opti frames is with screws.
• Screws and plastic wall plugs are included with every snap frame we supply
• The wall plugs are for use with masonry walls such as brick and most plastered walls 
• When screwing onto wood the plugs are not needed 
• A drill and screwdriver are required for screw fixing (and we recommend using a spirit level and tape measure to ensure the frames are properly aligned). If in doubt please consult a proficient DIY or trades person.

Fix Opti frames using adhesive tape

• Rolls of double-side adhesive tape are available as an accessory item.
• If double-side adhesive tape is used to fix frames (in place of the screws supplied) please check the smoothness and suitability of the wall.
• Tiles and similar surfaces may be suitable provided they are cleaned thoroughly before application.
• Tape fixing is not suitable for surfaces with a non-stick coating or porous/foamed surfaces. 
• We recommend that tape is used around the full perimeter of the frame.
• Larger frames are normally best screwed. A residue of foam tape will be left on the wall or door after removal of the frame and the frame will usually be hard to get off.